Print Settings for Drawer Organizers
By Marco · Updated 2026-11-15
Drawer organizers are large, flat and mostly walls. That makes them easy to print, but also prone to warping corners and long print times if you use the wrong settings.
Material
PLA is the best choice for almost every organizer: it is cheap, stiff and barely warps. Use PETG if the organizer will sit somewhere warm (a car, a sunny windowsill) or needs to flex a little without cracking. ABS and ASA are rarely worth the extra effort for indoor storage.
Recommended settings (0.4 mm nozzle, PLA)
| Setting | Value | Why |
|---|---|---|
| Layer height | 0.2–0.28 mm | Walls are vertical, so thicker layers save a lot of time without looking worse. |
| Wall loops / perimeters | Enough to fill the wall | A 1.6 mm wall = 4 lines of 0.4 mm. The slicer then prints the wall solid with no infill gaps. |
| Top/bottom layers | Bottom: floor ÷ layer height | A 1.2 mm floor at 0.2 mm = 6 solid layers, so the floor is fully solid. |
| Infill | Irrelevant (0–15%) | With matching wall and floor values there is almost nothing left to infill. |
| Supports | Off | The box has no overhangs. |
| Brim | 3–5 mm for boxes over 150 mm | Holds the corners down on long, flat parts. |
Match the wall to your line width
The single most useful trick: make the wall thickness a multiple of your extrusion line width. With a 0.4 mm line, 0.8, 1.2 and 1.6 mm walls print as 2, 3 and 4 clean lines. Odd values like 1.5 mm leave a thin gap that the slicer fills with zig-zag moves, which is slower and weaker.
Preventing warped corners
- Clean the bed with isopropyl alcohol or dish soap and water – grease from fingers is the most common cause.
- Slow down the first layer and make sure it is slightly squished.
- Add a brim on anything longer than about 150 mm.
- Use rounded outer corners in the generator: sharp 90° corners lift first.
- Avoid drafts – a closed room or an enclosure helps on large prints.
Elephant's foot and fit
The first layer is often squished a bit wider than the rest, which can make a box that fits on paper too tight in the drawer. Most slicers have an "elephant foot compensation" setting (0.1–0.2 mm). Combined with 2 mm of clearance in the generator, this is usually enough for a perfect fit.
Estimating filament
The generator shows an approximate filament weight for every model. Organizers are almost entirely wall and floor, so this estimate is close to what your slicer will report. As a rule of thumb, a 200 × 160 × 40 mm organizer with eight compartments uses roughly 150 g of PLA.
Next step: generate your organizer.